furnace charge
英 [ˈfɜːnɪs tʃɑːdʒ]
美 [ˈfɜːrnɪs tʃɑːrdʒ]
炉料
双语例句
- Dynamic simulation of transmission system of blast furnace top charge distributor
高炉炉顶布料器传动系统动力学仿真 - The supply of the furnace charge provides the necessary guarantee for the iron and steel companies, but the unstable and complicated market environment exists while purchasing furnace charge.
钢铁炉料为钢铁企业生产提供了必要的物质保证，而钢铁炉料采购面临的是一个动荡起伏、复杂多变的市场环境。 - It expoundes basic moving laws of furnace charge and gas from HC FeCr smelting in electric arc furnace.
论述了矿热炉冶炼高碳铬铁炉内炉料和炉气的基本运动规律。 - The low purity of furnace charge and accessories and the improper smelting and pouring crafts were regarded as the formation reason of the oxide film.
同时，分析认为这种氧化膜的形成与金属炉料、铸造辅料的洁净度不够以及熔炼、浇注不合理有关。 - Optimization method for operation planning of special furnace hot charge mode
专用炉混装模式下作业计划优化方法 - Through long experience the craft of iron casting, including making the stone moulds, furnace structure, charge composition, mould parching and casting, has reached a high level here.
从石范刻制、熔炉构造、炉料配比到烘范、浇注等工序都相当成熟，表明这项技术经过长期经验积累达到了较高水平。 - This paper discusses the influence on calcium carbide production of lime material, carbon material as well as the furnace charge proportion and operation.
讨论了石灰原料、碳素原料以及炉料酌情比和操作对电石生产的影响。 - A Two Stage Method for Optimal Scheduling Problem of Reheating Furnace in Hybrid Charge Mode Production
两阶段法求解混装模式下的加热炉调度 - The gas flow in blast furnace with various burden charge patterns has been analyzed by numerical simulation with finite difference method.
用有限差分法对高炉内气体流动行为进行了数值解析，并系统地分析了不同料床结构对气体流动行为的影响。 - The results present that the thermal regulation of heat furnace with hot charge should be alternated according to the theory of heat furnace.
应用拖偶测温法和加热炉热平衡测定等试验方法分析评价了攀钢轨梁厂现行的加热炉热工制度和钢坯的加热质量。 - In the practice, it has been proved that this method can not only remove the heredity but also minimize the cost of furnace charge.
即能消除铸造生铁的遗传性，又能保证炉料成本最低。 - The results indicate that fuzzy linear programming contributes to the decrease in furnace charge cost, efficient use of production facility and techniques, and rational selection of furnace charge, without doing damage to the quality of hot iron.
结果表明，采用模糊线性规划方法，在保证铁水品质的同时，能最大限度地利用本企业的生产设备和工艺，合理地选择炉料，从而降低炉料成本。 - To improve the softening-melting properties of the sinter, the structure of furnace charge is suggested to change reasonably, mixing the low-MgO-content sinter with magnesite or high-MgO-content sinter with acidic pellet.
采用合理的炉料结构，如低MgO烧结矿配加菱镁石块工艺，高MgO烧结矿配加酸性球团矿工艺等均可改善烧结矿的高温软熔性能。 - Brief introduction of the practice of furnace dry-out and with charge for chrome FERROALLOYS FURNACE
铬合金电炉烘炉与带料烘炉实践简介 - Thermotechnical information and data series: thermo-physical properties of fuel and furnace charge in iron and steel industry ( papt 4)
钢铁工业用燃料和炉料的热物理性质（连载4） - Physical structural features of sintered high basicity blast furnace charge
高碱度烧结矿的物理结构特征及测定 - As the holding time increases, the tensile properties of the samples, made of both kinds of the furnace charge, slightly improve.
随保温时间的延长，两种炉料重熔后的力学性能均得到了提高。 - A reduction in additional furnace charge and oxygen consumption were obtained and pure blowing time as well as tap to tap time was also reduced.
副原料及氧气消耗均有所降低；纯吹氧时间和冶炼周期有所缩短； - Optimization model and its application to furnace charge of stainless steel melting
不锈钢优化配料模型及其应用 - The article introduces the production capacity of available synthetic ore in Angang, analyses needful quantity, assortment and quality of furnace charge for producing 16Mt/ a hot metal in Angang and the methods and presents measures for resolving furnace charge shortage.
简要介绍了鞍钢现有人造富矿生产能力，分析了鞍钢生产1600万t/a生铁所需要的炉料数量、品种和质量，并提出了解决炉料缺口的方法和措施。 - The paper introduces the reasons of furnace charge's rising in the bottom in production Cr-Si alloy.
介绍了硅铬合金生产中造成炉底上涨的原因。 - Actual production observation is made of the sintering process for the phosphorus furnace charge in the large yellow phosphorus unit introduced from abroad by the orthogonal statistical method.
运用正交统计方法，对大型引进黄磷装置磷炉原料的烧结工艺进行生产过程实测。 - Since taking some measures, for example decreasing the specific area of furnace charge, controlling charging sequence, improving removing slag operation, etc, the melting loss of aluminium alloy is decreased from 30% to 1.6% in Zibo aluminium plant.
淄博铝厂在生产中采取了减小炉料比表面积，严格装料顺序，改进扒渣操作等措施，使反射炉熔炼铝合金的熔损由3.0%降至1.6%。 - A simplified and practical calculation for different constituents of furnace burden was proposed based on the features of furnace charge for non ferrous alloy melting.
根据生产中有色合金熔炼配料的特点，提出了一种简单、实用的炉料各组分的计算方法。 - Application and Development of Metering Control System of Flash Furnace Concentrate Charge
闪速炉精矿装入量计量控制系统开发与应用 - It is shown that the attenuation is determined mainly by the scattering and absorption cross section of the furnace charge and its number density.
研究表明，引起声波在炉料中的衰减主要由单个炉料的散射截面和吸收截面的几何平均数与炉料数密度的乘积决定。 - The development of EAF for steelmaking from single shell to twin shell furnace and continuous charge was described, especially their technical characteristics of the furnace types.
叙述了炼钢电弧炉从单炉壳型的发展向双炉壳型和连续装料型发展的状况，着重介绍了上述三种炉型技术发展的特点。 - Optimizing furnace charge composition by applying mathematics model
采用数学模型法优化炉料结构 - With the development of steel industry, oxidized pellet has gradually become more and more important metallurgical furnace charge.
伴随着钢铁工业的迅猛发展，氧化球团逐渐成为越来越重要的冶金炉料。 - Besides, a series of problems can be caused, such as lock of furnace charge, overflowing foam, deteriorated condition of blast furnace, increasing loss of iron and decrease in desulfuration rate.
另外，还会引起炉料堵塞和泡沫泛滥，导致高炉炉况恶化，铁损增加，脱硫率下降等。